Ningbo Anson Hi Series Error Er108: Error parameters calibration

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr108

Error parameters calibration happens when special parameter storage fails. The manual's first action is: “If the encoder is HEIDENHAIN encoder, please check EC. 32.If EC. 32 is not stored successfully, The zero needs to be adjusted once again.”

Model
Ningbo Anson Hi Series
Display shows
Error parameters calibration (Er108)
Type
Error code
Source
Manual p. 88

What Er108 means

Error parameters calibration p. 88

Common causes

  • The storage of special parameters failure. p. 88

What to do

  1. If the encoder is HEIDENHAIN encoder, please check EC. 32.If EC. 32 is not stored successfully, The zero needs to be adjusted once again. p. 88

If Er108 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 88 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er108; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.