Ningbo Anson Hi Series Error Er113: Error factory default setting

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEr113

Error factory default setting occurs when resetting to factory defaults fails. The manual's first action is: “Please operate once again”

Model: Ningbo Anson Hi Series
Display shows: Error factory default setting (Er113)
Type: Error code
Source: Manual p. 88

Meaning
Common causes
What to do
Still not solved
Source

What Er113 means

Error factory default setting p. 88

Common causes

Factory default setting failures. p. 88

What to do

Please operate once again p. 88

If Er113 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 88 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er113; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.