Mitsubishi Electric 600M Series Error OPW0113: Block start interlock

CNC milling machine · taken from the manufacturer’s manual, pages cited

Warning codeOPW0113

An interlock signal has been input that locks the start of a block in the sequence program. The manual's first action is: “Check the sequence program. Restart the program while simultaneously canceling the signal.”

Model
Mitsubishi Electric 600M Series
Display shows
Block start interlock (OPW0113)
Type
Warning code
Source
Manual p. 501

What OPW0113 means

Block start interlock p. 501

Common causes

  • An interlock signal that locks the start of the block has been input. p. 501

What to do

  1. Check the sequence program. Restart the program while simultaneously canceling the signal. p. 501

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0113 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 501 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0113; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.