Mitsubishi Electric 600M Series Error OPW0111: External feedrate zero

CNC milling machine · taken from the manufacturer’s manual, pages cited

Warning codeOPW0111

The manual feedrate switch is set to "0" during jog or dry run mode, or there's a short circuit in the signal wire or sequence program error. The manual's first action is: “Set the switch to a value other than "0" to release the error.”

Model
Mitsubishi Electric 600M Series
Display shows
External feedrate zero (OPW0111)
Type
Warning code
Source
Manual p. 501

What OPW0111 means

External feedrate zero p. 501

Common causes

  • The MANUAL FEEDRATE switch on the machine operation panel is set to "0" when the machine is in the jog mode or automatic dry run mode. p. 501
  • If the switch is set to a value other than "0", check for a short circuit in the signal wire. p. 501
  • Check the sequence program. p. 501

What to do

  1. Set the switch to a value other than "0" to release the error. p. 501

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0111 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 501 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0111; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.