Mitsubishi Electric 600M Series Error OPW0110: Rapid feed override zero

CNC milling machine · taken from the manufacturer’s manual, pages cited

Warning codeOPW0110

The rapid traverse override switch is set to "0". The manual's first action is: “Cancel the error by setting the "RAPID TRAVERSE OVERRIDE" switch to a value other than "0".”

Model
Mitsubishi Electric 600M Series
Display shows
Rapid feed override zero (OPW0110)
Type
Warning code
Source
Manual p. 500

What OPW0110 means

Rapid feed override zero p. 500

Common causes

  • The "RAPID TRAVERSE OVERRIDE" switch on the machine operation panel is set to "0". p. 500

What to do

  1. Cancel the error by setting the "RAPID TRAVERSE OVERRIDE" switch to a value other than "0". p. 500
  2. If the "RAPID TRAVERSE OVERRIDE" switch is set to a value other than "0", check for short-circuits in the signal wire. p. 500
  3. Check the sequence program. p. 500

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0110 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 500 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0110; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.