Mitsubishi Electric 600M Series Error OPW0109: Cutting override zero

CNC milling machine · taken from the manufacturer’s manual, pages cited

Warning codeOPW0109

The cutting feed override switch is set to "0". The manual's first action is: “Set the switch to a value other than "0" to cancel the error.”

Model
Mitsubishi Electric 600M Series
Display shows
Cutting override zero (OPW0109)
Type
Warning code
Source
Manual p. 500

What OPW0109 means

Cutting override zero p. 500

Common causes

  • The cutting feed override switch on the machine operation panel is set to "0". p. 500

What to do

  1. Set the switch to a value other than "0" to cancel the error. p. 500
  2. If the switch is set to a value other than "0", check for a short circuit in the signal wire. p. 500
  3. Check the sequence program. p. 500

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0109 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 500 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0109; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.