Mitsubishi Electric 600M Series Error AX0103: Dog overrun

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codeAX0103

During reference point return, the near-point dog was passed over without stopping, likely due to insufficient length or misalignment. The manual's first action is: “Increase the length of the near-point dog.”

Model
Mitsubishi Electric 600M Series
Display shows
Dog overrun (AX0103)
Type
Error code
Source
Manual p. 474

What AX0103 means

Dog overrun p. 474

Common causes

  • During the reference point return, the limit switch for near-point detection passed over the dog without being able to stop on it. p. 474

What to do

  1. Increase the length of the near-point dog. p. 474
  2. Decrease the reference point return speed. p. 474
  3. (Note) An error does not occur in some systems, depending on the system type. p. 474

Before you service the product, read the safety instructions in the manual p. 4.

If AX0103 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 474 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about AX0103; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.