Mitsubishi Electric 600M Series Error OP0101: Stroke end axis exists

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codeOP0101

Automatic operation paused because an axis has reached its physical stroke end; manual intervention is required after reset. The manual's first action is: “After resetting, cancel the stroke end by a manual operation.”

Model
Mitsubishi Electric 600M Series
Display shows
Stroke end axis exists (OP0101)
Type
Error code
Source
Manual p. 476

What OP0101 means

Stroke end axis exists p. 476

Common causes

  • The automatic operation paused because an axis exists that is at its stroke end. p. 476

What to do

  1. After resetting, cancel the stroke end by a manual operation. p. 476

Before you service the product, read the safety instructions in the manual p. 4.

If OP0101 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 476 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OP0101; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.