CANopen fault—Duplicate synchronization signal happens when multiple slave nodes generate synchronization signals in the network. The manual's first action is: “Modify configuration so that there is only one synchronization signal generation source in the entire communication network.”
- Model
- INVT DA180
- Display shows
- CANopen fault—Duplicate synchronization signal (Er26-d)
- Type
- Fault code
- Source
- Manual p. 259
What Er26-d means
CANopen fault—Duplicate synchronization signal p. 277
Common causes
- In the case where a slave node is configured to generate synchronization signals, synchronization signals are received. p. 277
What to do
- Modify configuration so that there is only one synchronization signal generation source in the entire communication network. p. 277
If Er26-d is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact INVT service.
This page summarises what the manufacturer’s manual says about Er26-d; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with INVT. Found a mistake? Report an error.