INVT DA180 Error Er25-5: Application fault—Encoder offset angle test failed

AC servo drive · taken from the manufacturer’s manual, pages cited

Fault codeEr25-5

Application fault—Encoder offset angle test failed occurs when there is great fluctuation in current feedback during encoder offset angle testing on the INVT DA180 drive. The manual's first action is: “Reduce the setting of P4.53 and then carry out the test after repower-on.”

Model: INVT DA180
Display shows: Application fault—Encoder offset angle test failed (Er25-5)
Type: Fault code
Source: Manual p. 259

Meaning
Common causes
What to do
Still not solved
Source

What Er25-5 means

Application fault—Encoder offset angle test failed p. 274

Common causes

There is great fluctuation in current feedback in the encoder offset angle test. p. 274

What to do

Reduce the setting of P4.53 and then carry out the test after repower-on. p. 274

If Er25-5 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact INVT service.

Open the manual at page 259 All DA180 error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er25-5; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with INVT. Found a mistake? Report an error.