INVT DA180 Error Er26-1: CANopen fault—SDO index not exist

AC servo drive · taken from the manufacturer’s manual, pages cited

Fault codeEr26-1

CANopen fault—SDO index not exist occurs when an SDO read or write attempts an index that doesn't exist in the object dictionary on the INVT DA180 drive. The manual's first action is: “Check the index on the master node and on the servo drive. Modify the index in the EDS file.”

Model
INVT DA180
Display shows
CANopen fault—SDO index not exist (Er26-1)
Type
Fault code
Source
Manual p. 259

What Er26-1 means

CANopen fault—SDO index not exist p. 275

Common causes

  • When the SDO reads or writes parameters, the index does not exist in the object. p. 275

What to do

  1. Check the index on the master node and on the servo drive. Modify the index in the EDS file. p. 275

If Er26-1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact INVT service.

Open the manual at page 259 All DA180 error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er26-1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with INVT. Found a mistake? Report an error.