Danfoss 100 FLOW Error ID 600: System Fault

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 600

System Fault occurs due to no communication between control board and power unit. The manual's first action is: “Reset the fault and restart the drive.”

Model
Danfoss 100 FLOW
Display shows
System Fault (ID 600)
Type
Fault code
Source
Manual p. 294

What ID 600 means

System Fault p. 294

Common causes

  • There is no communication between the control board and the power unit. p. 294

What to do

  1. Reset the fault and restart the drive. p. 294
  2. Download the latest software from the Danfoss Drives website. Update the drive with it. p. 294
  3. If the fault occurs again, ask for instructions from your nearest distributor. p. 294

If ID 600 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 294 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 600; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.