Danfoss 100 FLOW Error ID 607: System Fault

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 607

System Fault occurs when software version cannot be read, indicating no software in power unit, defective component, or board malfunction. The manual's first action is: “Reset the fault and restart the drive.”

Model
Danfoss 100 FLOW
Display shows
System Fault (ID 607)
Type
Fault code
Source
Manual p. 295

What ID 607 means

System Fault p. 295

Common causes

  • The software version cannot be read. There is no software in the power unit. p. 295
  • Defective component. p. 295
  • Operation malfunction (a problem in the power board or the measurement board). p. 295

What to do

  1. Reset the fault and restart the drive. p. 295
  2. Download the latest software from the Danfoss Drives website. Update the drive with it. p. 295
  3. If the fault occurs again, ask for instructions from your nearest distributor. p. 295

If ID 607 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 295 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 607; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.