Danfoss 100 FLOW Error ID 137: Overvoltage Protection Circuit Temperature (Fault)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 137

Overvoltage Protection Circuit Temperature (Fault) happens when output capacitance is too high or there’s a ground fault in the floating network. The manual lists no action for this code.

Model
Danfoss 100 FLOW
Display shows
Overvoltage Protection Circuit Temperature (Fault) (ID 137)
Type
Fault code
Source
Manual p. 300

What ID 137 means

Overvoltage Protection Circuit Temperature (Fault) p. 300

Common causes

  • Too high an output capacitance or a ground fault in the floating network. p. 300

If ID 137 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 300 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 137; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.