Danfoss 100 FLOW Error 11: ID 100 - Output Phase Supervision

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code11

ID 100 - Output Phase Supervision indicates no current in one motor phase due to motor/cable malfunction or filter failure. The manual's first action is: “Check the motor cable and the motor.”

Model
Danfoss 100 FLOW
Display shows
ID 100 - Output Phase Supervision (11)
Type
Fault code
Source
Manual p. 299

What 11 means

ID 100 - Output Phase Supervision p. 299

Common causes

  • The current measurement tells that there is no current in 1 motor phase. p. 299
  • A motor or motor cables malfunction. p. 299
  • Filter (dU/dt, sine wave) malfunction. p. 299

What to do

  1. Check the motor cable and the motor. p. 299
  2. Check the dU/dt or sine wave filter. p. 299

If 11 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 299 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 11; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.