Danfoss 100 FLOW Error 17: Motor Underload

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code17

Motor Underload indicates insufficient load or parameter/filter issues causing underload condition. The manual's first action is: “Check the load.”

Model
Danfoss 100 FLOW
Display shows
Motor Underload (17)
Type
Fault code
Source
Manual p. 301

What 17 means

Motor Underload p. 301

Common causes

  • There is not a sufficient load on the motor. p. 301
  • Check the parameters. p. 301
  • Check the dU/dt and sine wave filters. p. 301

What to do

  1. Check the load. p. 301

If 17 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 301 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 17; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.