Danfoss 100 FLOW Error ID 240: Motor Control Fault

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 240

Motor Control Fault occurs during start angle identification if rotor moves or new angle doesn’t match old value, specific to customer applications. The manual's first action is: “The rotor moves during identification.”

Model
Danfoss 100 FLOW
Display shows
Motor Control Fault (ID 240)
Type
Fault code
Source
Manual p. 302

What ID 240 means

Motor Control Fault p. 302

Common causes

  • This fault is available only if you use a customer-specific application. A malfunction in the start angle identification. p. 302

What to do

  1. The rotor moves during identification. p. 302
  2. The new angle does not agree with the old value. p. 302

If ID 240 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 302 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 240; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.