The template name used in the geometry description file exceeds 255 characters. The manual's first action is: “Among the other parameters, the geometry template description always contains the geometry template name. The above error message means that the length of the name exceeds 255 characters. Change the name, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #365
- Type
- Error code
- Source
- Manual p. 422
What #365 means
TEMPLATE NAME USED IN THE GEOMETRY DESCRIPTION FILE IS TOO LONG. p. 422
Common causes
- Change the name, then try again. p. 422
What to do
- Among the other parameters, the geometry template description always contains the geometry template name. The above error message means that the length of the name exceeds 255 characters. Change the name, then try again. p. 422
Before you service the product, read the safety instructions in the manual p. 526.
If #365 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #365; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.