The declared detector name specified via the :DETECTOR keyword in SPACE.INI was not found. The manual's first action is: “The :DETECTOR keyword determines the file that is used to store the descriptions of the available detectors. Each detector description includes a detector name that is used as reference to identify the required detector in the geometry template description. The above error message means that the detector name indicated in the geometry template description was not found in the file with detector descriptions. Make sure that the required detector name is included in the file with detector descriptions. Then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- DECLARED DETECTOR NAME IS NOT FOUND. (#363)
- Type
- Error code
- Source
- Manual p. 422
What #363 means
DECLARED DETECTOR NAME IS NOT FOUND. p. 422
Common causes
- Check the file indicated via the :DETECTOR_PAR keyword in SPACE.INI file. p. 422
What to do
- The :DETECTOR keyword determines the file that is used to store the descriptions of the available detectors. Each detector description includes a detector name that is used as reference to identify the required detector in the geometry template description. The above error message means that the detector name indicated in the geometry template description was not found in the file with detector descriptions. Make sure that the required detector name is included in the file with detector descriptions. Then try again. p. 422
Before you service the product, read the safety instructions in the manual p. 526.
If #363 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #363; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.