Density values are not allowed when using default material names in the beaker description file. The manual's first action is: “Remove the density value for the defaulted material name. Then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #1109
- Type
- Error code
- Source
- Manual p. 428
What #1109 means
DENSITY VALUE IS NOT ALLOWED IF DEFAULT MATERIAL NAME IS USED IN THE BEAKER DESCRIPTION FILE. p. 428
Common causes
- The beaker description may use the default material name in any row of description except the 1st row. However, a density value should not be entered if the material name in a row is indicated as default. p. 428
What to do
- Remove the density value for the defaulted material name. Then try again. p. 428
Before you service the product, read the safety instructions in the manual p. 526.
If #1109 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #1109; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.