Industrial

The LM2679 is a high efficiency 5A step-down switching regulator with adjustable current limit. It features a low ON-resistance DMOS power switch and achieves up to 92% conversion efficiency. The device uses a fixed frequency oscillator (260KHz) which allows for smaller physical components.

This document is a product specification sheet, which introduces the 74HC/HCT221 dual non-retriggerable monostable multivibrator with reset. The features include low pulse width variance, pin-out identical to '123', overriding reset to terminate output pulse, hysteresis on nB inputs for improved noise immunity, etc.

The ISP1160 is an embedded Universal Serial Bus (USB) Host Controller (HC) that complies with Universal Serial Bus Specification Rev. 2.0, supporting data transfer at full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s).

The USBIO24 R is a low-cost integrated module for the input and/or output of digital signals from a computer system by connection to the USB port. The module features 24 independently programmable input/output pins that can be used as input or output. Multiple modules can be connected to a single PC via a USB hub. Each module has a unique serial number, allowing for multiple modules to be connected for a single application. The outputs of the module can source or sink up to 30mA per I/O, up to a maximum of 50mA per port, to allow for direct connection to a variety of devices. The module is powered by the USB from the PC or by an external power supply.

The TPS2375/77 is TI’s second generation IEEE 802.3af PoE powered device controller with 100-V ratings and a 0.58-Ω low-side switch. It integrates all the necessary features to develop a compliant powered device (PD).

The TS921 is a high output current single voltage operational amplifier produced by Texas Instruments. It has low noise, low distortion, high output current and other features. It is suitable for headphone amplifiers, piezoelectric speaker drivers, sound cards, multimedia systems, line drivers, actuator drivers, servo amplifiers, mobile phones and portable communication devices.

This document introduces the features of the CS4382A product, including 24-bit conversion, up to 192kHz sampling rate, 114dB dynamic range, -100dB THD+N, Direct Stream Digital Mode, On-chip 50 kHz filter, Matched PCM and DSD analog output levels, Selectable Digital Filters, Volume Control with 1-dB Step Size and Soft Ramp, Low Clock Jitter Sensitivity, +5 V Analog Supply, +2.5 V Digital Supply, Separate 1.8 to 5 V Logic Supplies for the Control & Serial Ports.

The LT3023 is a dual, micropower, low noise, low dropout regulator. It can provide 100mA of output current with a dropout voltage of 300mV. Its quiescent current is 20μA and its shutdown current is less than 0.1μA.

CNY17F is an optocoupler consisting of a gallium arsenide infrared emitting diode optically coupled to a silicon planar phototransistor detector in a plastic plug-in DIP-6 package. It has features such as isolation test voltage, no base terminal connection for improved common mode interface immunity, and long term stability.

This document describes the features of AT45DB021D, AT45DB021D is a 2.7V, serial-interface Flash memory, ideally suited for a wide variety of digital voice-, image-, program code- and data-storage applications.

Hirschmann measuring and testing products include a comprehensive range of shockproof measuring leads and accessories. From miniature connectors for safety extra-low voltage to safety-type products for measuring tasks up to 1.000 V.

This manual introduces the Telit EVK2 overview, generality, description, startup procedure, insertion of the interface boards and power supply setting contents

The product is a frequency translator that supports output frequencies up to 777.60 MHz. The input frequency range is from 333 Hz to 170 MHz, and it supports frequencies such as 8 kHz, 1.544 MHz, 2.048 MHz, 19.440 MHz, etc. It can be applied to SONET/SDH/ATM, DWDM/FDM, DSL-PON Interconnects, FEC (Forward Error Correction) and other scenarios.

AD7569/AD7669 is a complete, 8-bit, analog I/O system on a single monolithic chip. It contains a high speed successive approximation ADC, a track/hold, a DAC and an output buffer amplifier, as well as a temperature-compensated 1.25 V bandgap reference that provides a precision reference voltage.