Industrial

The LM3710/LM3711 series of microprocessor supervisory circuits provide the maximum flexibility for monitoring power supplies and battery controlled functions in systems without backup batteries

The document introduces several products with different features and characteristics, including 6dB attenuators and CFU455 series and CFWS455 series products.

HIP6017 Advanced PWM and Dual Linear Power Control for High-Performance Microprocessor and Computer Applications

The LM3478 is a high efficiency, low side N-channel switching regulator controller from TI. It is suitable for use in topologies requiring low side FET, such as boost, flyback, SEPIC, etc. The device operates at extremely high switching frequency, and has built in features such as thermal shutdown, short-circuit protection, over voltage protection, etc.

LM34/LM34A/LM34C/LM34CA/LM34D Precision Fahrenheit Temperature Sensors

The LM346 is a programmable quad bipolar operational amplifier with programmable electrical characteristics, low supply current, high gain, low noise voltage, wide power supply range, no crossover distortion and overload protection

ST7MC1/ST7MC2 8-bit MCU with nested interrupts, flash, 10-bit ADC, brushless motor control, five timers, SPI, LINSCI™

LF155/LF156/LF256/LF257/LF355/LF356/LF357 are the first monolithic JFET input operational amplifiers to incorporate well matched, high voltage JFETs on the same chip with standard bipolar transistors (BI-FET™ Technology). These amplifiers feature low input bias and offset currents/low offset voltage and offset voltage drift, coupled with offset adjust which does not degrade drift or common-mode rejection. The devices are also designed for high slew rate, wide bandwidth, extremely fast settling time, low voltage and current noise and a low 1/f noise corner.

This document describes the features and characteristics of Composite Transistors XN06211 (XN6211), which is a silicon NPN epitaxial planar transistor for switching/digital circuits. The product incorporates two elements into one package, reducing the mounting area and assembly cost. The document also provides the absolute maximum ratings and electrical characteristics of the product.

LC74FCT16245T and LC74FCT162245T 16-bit transceivers are fabricated in an advanced two-metal-layer CMOS technology. These fast, low-power transceivers are optimal for synchronous communication between two buses, referred to as the A and B busses. The directionality and output enable control in these products is designed to allow them to be used as either two independent 8-bit transceivers or as a single 16-bit transceiver. The direction control pin (× DIR) controls the data flow direction and the output enable pin (× OE) disables directionality control and disables both ports. The LC74FCT16245T is optimal for driving large-capacitance loads and low-impedance loads. The LC74FCT162245T provides a balanced output drive function that incorporates current limiting resistors. These minimize ground bounce and undershoot, and limit the output fall time. As a result, external series terminating resistors are no longer required. The LC74FCT162245T is a plug-in replacement for the LC74FCT16245T in on-board interface applications.

The LC72700E and LC72700G are data decoder LSIs for receiving DARCTM mobile FM multiplex broadcasts. A multi-function, compact, adjustment-free system can be implemented in two chips by combining this LSI with the LV3400M band-pass filter IC, which extracts the multiplex components from a composite FM signal.

The LC66P2316 is an on-chip OTP PROM version of the LC6623XX Series CMOS 4-bit single-chip microcontrollers. It has a capacity of 16 kilobytes of OTP ROM and 512 × 4 bits of on-chip RAM. It fully supports the common instruction set of the LC66000 Series. It has 36 I/O ports, powerful timer functions and prescalers, and flexible I/O functions.

The MF10 is a universal monolithic dual switched capacitor filter that is easy to use and provides high performance. It can produce various 2nd order filter functions.