Industrial

STPS16H100CT/CG/CFP/CR is a high-voltage power Schottky rectifier from ST company. Its features are negligible switching losses, high junction temperature capability, low leakage current, good trade-off between leakage current and forward voltage drop, and avalanche capability.

ST72260G, ST72262G, ST72264G 8-bit MCUs are single-chip microcontrollers with FLASH or ROM memory, ADC, two 16-bit timers, I2C, SPI, SCI interfaces.

ST6208C/ST6209C ST6210C/ST6220C 8-BIT MCUs with A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET

SPL MN81G2 is a passively cooled diode laser bar with 50W cw output power at 808nm. It features a passive heat sink design that does not require cooling water. It is suitable for continuous wave (cw) and quasi-continuous wave (qcw) operation. The laser bar utilizes highly reliable semiconductor material with a minimum lifetime of 10,000 hours, typically exceeding 50,000 hours. It has low thermal resistance, low smile (<2.5 μm), and low mechanical tolerances. The applications include pumping of solid state lasers, direct industrial applications (soldering, surface treatment, etc.), medical applications, and printing applications.

The SPI-236-17 is a compact photo-interrupter with a GaAs infrared LED and a single phototransistor. It features wide operating ranges and low power consumption.

SPB-37120W-1590G is a single-fiber SFP transceiver produced by Optoway. It supports the IEEE 802.3ah 100BASE-BX standard and has a 1590nm DFB LD transmitter and a 1510nm receiver. The distance can reach 120km and the working temperature is 0 to 70oC. It supports RoHS standards.

The SP8402 is a very low phase noise divider which divides by powers of two. It features data inputs for selecting the division ratio and special circuit techniques to reduce phase noise below that of standard dividers.

The SP6122 is a low voltage, micro 8, PFET, buck controller from Sipex Corporation, ideal for 1A to 5A, small footprint, DC-DC power converters.

This datasheet is the technical specifications of Sipex SP231A/232A/233A/310A/312A.

The SP1481E is a half-duplex transceiver that meets the specifications of RS-485 and RS-422 serial protocols with enhanced ESD performance. The ESD tolerance has been improved on this device to over +15KV for both Human Body Model and IEC1000-4-2 Air Discharge Method. This device is pin-to-pin compatible with Sipex's SP485 and SP481 devices as well as popular industry standards. As with the original version, the SP1481E features Sipex's BiCMOS design allowing low power operation without sacrificing performance. The SP1481E meets the requirements of the RS-485 and RS-422 protocols up to 20Mbps under load.

This data sheet provides detailed information about the SN54LVTH574 and SN74LVTH574 3.3-V ABT octal edge-triggered D-type flip-flops, including electrical specifications, package options, and applications information.

Introduces the characteristics of SN74LVT240A

SN74AVCH245 is a low-power, high-performance, low-noise, high-speed, three-state output bus transceiver. It has a dynamic output control circuit, which can lower the output impedance when the signal is in transition, improve the load driving ability, and increase the output impedance when the signal is stable, reducing noise.

This manual provides instructions for the operation and maintenance of the Agilent 490 Micro GC Biogas Analyzer.

This document is a user guide for Agilent Technologies' Agilent G4900DA Scanner per microarray SureScan Software Microarray Scan Control 9.1. The product is intended for research purposes only and cannot be used for diagnostic procedures.