Industrial

MAX 3000A is a high-performance, low-cost CMOS EEPROM-based PLD device family from Altera Corporation. It is based on the Multiple Array MatriX (MAX®) architecture and supports 3.3V in-system programmability (ISP). The series provides devices with 600 to 5,000 usable gates.

MAX 3000A is a high-performance, low-cost PLD based on CMOS EEPROM developed by Altera Corporation. It uses MAX architecture and has 3.3V in-system programmability (ISP), high-density PLD, 4.5-ns pin-to-pin logic delays, MultiVoltTM I/O interface and other features.

This data sheet provides detailed information about the Altera MAX3000A programmable logic devices (PLDs), including features, characteristics, pin counts, packages, voltages, etc.

This document describes the features and characteristics of the Altera MAX 3000A programmable logic device family, including high performance, low cost, EEPROM-based architecture, 3.3V in-system programmability, built-in JTAG interface, boundary-scan test, etc.

This document introduces the JTAG and In-System Programmability features of the Altera MAX II devices.

The A2526EL/M and A2536EL/M are integrated high-side dual power switches, optimized for self-powered and bus-powered Universal Serial Bus (USB) applications. Few external components are necessary to satisfy USB requirements. Each switch channel supplies up to 500 mA as required by USB peripheral devices. In addition, the switch’s low on-resistance permits achieving the USB voltage-drop requirements. Fault current is limited to typically 750 mA, satisfying the UL 25 VA safety requirements, and a flag output is available to indicate a fault condition to the local USB controller. Momentary voltage drops that may occur on the upstream port when the switch is enabled in bus-powered applications is eliminated by a “soft start” feature. Additional features include thermal shutdown to prevent catastrophic switch failure from high-current loads, undervoltage lockout to ensure that the device remains OFF unless there is a valid input voltage present, and 3.3 V and 5 V logic-compatible enable inputs. These switches are provided in 8-pin mini-DIP (suffix ‘M’) and 8-lead SOIC (suffix ‘L’) packages.

A2525EL/M and A2535EL/M are integrated high-side power switches, optimized for self-powered and bus-powered Universal Serial Bus (USB) applications

This document is the operation manual for the T9i Treadmill, which mainly introduces the functions and usage methods of the equipment

This manual contains instructions for installing and maintaining the 9390IT 20-40 kVA and 9390 20-80 kVA UPS models.

A1391-DS is the datasheet of A1391 and A1392, it is a micro power 3V linear hall effect sensor with tri-state output and user-selectable sleep mode. This integrated circuit (IC) provides a voltage output that is directly proportional to an applied magnetic field. In many applications, it is difficult to achieve sufficient sensitivity levels with a Hall effect sensor IC without consuming more than 3 mA of current. The A1391 and A1392 minimize current consumption to less than 25 μA through the addition of a user-selectable sleep mode.

This manual describes the operation methods of FP+ series Dedicated Touring Amplifiers

The SMP30-xxx series is a bidirectional crowbar protection device with a rated voltage range of 62V to 270V. It has a minimum holding current of 150mA and a 30A 10/1000µs repetitive peak pulse current. The series uses a JEDEC registered SMA (JEDEC DO-214AA) package. The SMP30-xxx series has been designed to protect telecommunications equipments against lightning surges and overvoltages induced by AC power lines.

The SMP30-xxx series is a bidirectional crowbar protection device designed to protect telecommunication equipment against lightning and transients induced by AC power lines. The package / die size ratio has been optimized by using the SMA package.