Industrial

The VN610SP is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving resistive or inductive loads with one side connected to ground. Active VCC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table). This device integrates an analog current sense which delivers a current proportional to the load current (according to a known ratio). Active current limitation combined with thermal shutdown and automatic restart protect the device against over-load. Device automatically turns off in case of ground pin disconnection.

The L9997ND is a dual half bridge driver from STMicroelectronics that is designed to drive various loads, including DC motors. The chip has very low quiescent current and features protection against undervoltage and overvoltage conditions. It also includes real time diagnostic functions.

The document describes the features of the OP113/OP213/OP413 series single-supply operational amplifiers, including low noise, low drift, wide bandwidth, low offset voltage, and low drift. They are suitable for applications such as digital scales, multimedia, strain gauges, and battery-powered instrumentation.

This data sheet introduces the features of L4953G, including 3 outputs: 9.2V (500mA), 5V (1A), 5V (100mA); 2A high side driver with clamped output (16V); logic output for: supply undervoltage (LVW), overvoltage, thermal protection; reset function; ignition comparator; reverse battery and load dump protection; thermal shutdown.

The L9613 is an integrated circuit from STMicroelectronics that contains standard ISO 9141 compatible interface functions. This product has very low static current, wide operating voltage range, reliable overvoltage protection, good EMI resistance, etc.

This datasheet introduces the features and characteristics of TDA7560, a breakthrough BCD (Bipolar/ CMOS/ DMOS) technology class AB audio power amplifier in Flexiwatt 25 package designed for high power car radio.

This document is about the VN750 high-side driver product information, introduces the characteristics and features of the product, including CMOS compatible input, on-state open-load detection, off-state open-load detection, shorted load protection, undervoltage and overvoltage shutdown, protection against loss of ground, very low standby current and reverse battery protection.

This document contains information about the products of the OP10 supplier, describing the features and characteristics of the product.

This document is about VNP35N07FI VNB35N07/VNV35N07 ”OMNIFET”: FULLY AUTOPROTECTED POWER MOSFET. It mainly introduces the technical features of the product, including linear current limitation, thermal shutdown, short circuit protection, integrated clamp, low current drawn from the input pin, diagnostic feedback through the input pin, ESD protection, direct access to the gate of the power MOSFET (analog driving), and compatibility with standard power MOSFETs.

The VNB49N04, VNV49N04 are monolithic devices designed in STMicroelectronics™ VIPower™ M0 technology, intended for replacement of standard Power MOSFETs from DC up to 50 KHz applications. Built-in thermal shutdown, linear current limitation and overvoltage clamp protect the chip in harsh environments. Fault feedback can be detected by monitoring the voltage at the input pin.

This datasheet provides the detailed technical information of OMNIFET VNB14N04, VNK14N04FM and VNV14N04, including the package type, pin configuration, electrical parameters, package dimensions, application circuits and so on.

This product is a MOSFET made by STMicroelectronics, with low resistance and low current limiting, suitable for DC to 50KHz applications.

VNV28N04 is a power MOSFET produced by STMicroelectronics. It has built-in thermal protection, linear current limiting and overvoltage clamp protection. It also has direct access to the gate of the power MOSFET.