STMicroelectronics Manuals

This document describes the features and characteristics of the TDA7381 4 x 25 W quad bridge car radio amplifier, including high output power capability, clipping detector, low distortion, low output noise, standby function, mute function, automute, and diagnostics facility.

The L9935 is a two-phase stepper motor driver circuit from ST that is suited to drive bipolar stepper motors. The device can be controlled by a serial interface (SPI). All protections required to design a well protected system (short-circuit, over temperature, cross conduction etc.) are integrated.

The TDA7479 is a single chip RDS demodulator and filter with very high RDS demodulation quality and improved digital signal processing.

The L9615 is a bidirectional transceiver for signal conditioning and processing in connection with a CAN controller. Data rates of up to 500KBAUD are supported using either shielded or non- shielded pair of lines.

The VN460SP is a single-channel high-side smart solid-state relay with a rated output current of 25A and a rated voltage of 36V. The product uses SGS-THOMSON Vertical Intelligent Power Technology and is intended for driving resistive or inductive loads with one side connected to ground. Built-in thermal shutdown protects the chip from over temperature and short circuit. The control input is 5V CMOS logic level compatible. The open drain diagnostic output indicates open circuit (no load) and overtemperature status.

L9380 is a three-channel N-channel high-side switch driver from STMicroelectronics. It is designed to replace relays in automotive electronic control units.

VND600SP is a double channel high-side solid state relay with features including DC short circuit current of 25A, CMOS compatible inputs, proportional load current sense, under-voltage and over-voltage shutdown, over-voltage clamp, thermal shutdown, current limitation, very low standby power consumption, protection against loss of ground and loss of VCC, and reverse battery protection.

The VN610SP is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving resistive or inductive loads with one side connected to ground. Active VCC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table). This device integrates an analog current sense which delivers a current proportional to the load current (according to a known ratio). Active current limitation combined with thermal shutdown and automatic restart protect the device against over-load. Device automatically turns off in case of ground pin disconnection.

The L9997ND is a dual half bridge driver from STMicroelectronics that is designed to drive various loads, including DC motors. The chip has very low quiescent current and features protection against undervoltage and overvoltage conditions. It also includes real time diagnostic functions.

This data sheet introduces the features of L4953G, including 3 outputs: 9.2V (500mA), 5V (1A), 5V (100mA); 2A high side driver with clamped output (16V); logic output for: supply undervoltage (LVW), overvoltage, thermal protection; reset function; ignition comparator; reverse battery and load dump protection; thermal shutdown.

The L9613 is an integrated circuit from STMicroelectronics that contains standard ISO 9141 compatible interface functions. This product has very low static current, wide operating voltage range, reliable overvoltage protection, good EMI resistance, etc.

This datasheet introduces the features and characteristics of TDA7560, a breakthrough BCD (Bipolar/ CMOS/ DMOS) technology class AB audio power amplifier in Flexiwatt 25 package designed for high power car radio.