STMicroelectronics manuals, page 18
ST BTA16B BTB16B March 1995 STANDARD TRIACS handbook1
BTA16 B BTB16 B are high performance glass passivated PNPN devices, suitable for general purpose applications where high surge current capability is required. For example, phase control and static switching on inductive or resistive load.
ST BTA/BTB16 T16 Series SNUBBERLESS LOGIC LEVEL STANDARD 16A TRIACS handbook
BTA/BTB16 and T16 Series SNUBBERLESS™ , LOGIC LEVEL & STANDARD 16A TRIACS, is a medium power triac launched by STMicroelectronics. This document provides a detailed introduction to the features and characteristics of this product
ST BTA/BTB12 T12 Series handbook
The BTA/BTB12 and T12 triac series are suitable for general purpose AC switching. They can be used as an ON/OFF function in applications such as static relays, heating regulation, induction motor starting circuits. or for phase control operation in light dimmers, motor speed controllers. The snubberless versions are specially recommended for use on inductive loads, thanks to their high commutation performances. Logic level versions are designed to interface directly with low power drivers such as microcontrollers. The BTA series provides voltage insulated tab (rated at 2500V RMS) complying with UL standards.
ST STBC21 Manual
ST ST1S15 handbook
The ST1S15 is a high efficiency miniaturized step-down converter able to provide 500 mA output current from an input voltage from 2.3 to 5.5. This converter is specifically designed for applications where high efficiency and small application area are the key factors. With an output voltage as low as 0.6 V the device supports low voltage DSPs and processors core supply. Due to the 6 MHz switching frequency the ST1S15 can use nominal values of 470 nH for the inductor and 4.7 µF for the output capacitor, providing, at the same time, very good performance in terms of load and line transients. It is possible to select a PFM mode for high efficiency under light load conditions or PWM mode for tight regulation and best dynamic performance. Short-circuit and thermal protection are included.
ST TLVH431 handbook
ST STBP112 handbook
STBP112 is an overvoltage protection device produced by ST company. It has input overvoltage protection, high voltage N-channel MOSFET switch, integrated charging pump, maximum continuous current of 2A, thermal shutdown, soft start and other characteristics. It is suitable for smart phones, digital cameras, PDAs, MP3 players and other devices.
ST L6718 handbook
This is preliminary information on a new product now in development or undergoing evaluation. The product is a digitally controlled dual PWM with embedded drivers for VR12 processors. It features VR12 compliance, compact design, high-current output, and various protection functions.
ST HVLED815PF handbook
HVLED815PF is a high power factor (>0.9) offline LED driver from ST, with a maximum operating current of 15W.
ST LED2000 handbook
The LED2000 is an 850 kHz fixed switching frequency monolithic step-down DC-DC converter designed to operate as precise constant current source with an adjustable current capability up to 3 A DC. The embedded PWM dimming circuitry features LED brightness control. The regulated output current is set connecting a sensing resistor to the feedback pin. The embedded synchronous rectification and the 100 mV typical RSENSE voltage drop enhance the efficiency performance. The size of the overall application is minimized thanks to the high switching frequency and ceramic output capacitor compatibility. The device is fully protected against thermal overheating, overcurrent and output short-circuit. The LED2000 is available in VFQFPN 4 mm x 4 mm 8-lead package, and standard SO8.
ST HVLED807PF handbook
The HVLED807PF is a high-voltage primary switcher intended to operate directly from the rectified mains with high power factor capability and efficiency, providing a cost-effective solution for LED driving.
ST ST1S32 4 A DC step-down switching regulator handbook
The ST1S32 is a 4A DC step-down switching regulator with an input voltage range of 2.8V to 5.5V. It features an adjustable output voltage down to 0.8V, a switching frequency of 1.5MHz, and internal soft-start and enable functions.
ST PM6644 350 mA adjustable step-down regulator handbook
The PM6644 is a 350mA valley current limit step-down regulator capable of delivering an adjustable output voltage in the range between 0.9 V and 8 V.
ST A7985A 2 A step-down switching regulator for automotive applications handbook
This document provides preliminary information on a new product currently in development or undergoing evaluation. Details are subject to change.
ST ST1S31 3 A DC step-down switching regulator handbook
ST1S31 is a 3A DC step-down switching regulator from ST. It adopts internally compensated 1.5MHz fixed-frequency PWM synchronous step-down circuit, with input voltage range of 2.8V~5.5V and output voltage adjustable range of 0.8V~VIN. It has a 60mΩ high-side switch and a 45mΩ synchronous rectifier, which can achieve high efficiency and low output voltage.