TEXAS Manuals

The ADS1271 is a high-performance 24-bit, delta-sigma analog-to-digital converter (ADC) with a data rate up to 105 kSPS, providing an exclusive combination of excellent DC accuracy and outstanding AC performance.

The TPS2211 is a single-slot PC card power interface switch that is compatible with various PCMCIA controllers. It features fully integrated VCC and Vpp switching, low rDS(on) (90-mΩ 5-V VCC switch and 3.3-V VCC switch), meets PC card standards, and provides short-circuit and thermal protection.

The ULN2001A, ULN2002A, ULN2003A, ULN2004A, ULQ2003A, and ULQ2004A are high-voltage, high-current Darlington transistor arrays. Each consists of seven npn Darlington pairs that feature high-voltage outputs with common-cathode clamp diodes for switching inductive loads. The collector-current rating of a single Darlington pair is 500 mA. The Darlington pairs can be paralleled for higher current capability. Applications include relay drivers, hammer drivers, lamp drivers, display drivers (LED and gas discharge), line drivers, and logic buffers.

MSP430 User’s Guide SLAU101F is a product document released by Texas Instruments Incorporated and its subsidiaries (TI). It contains detailed information about the product, including product features, characteristics, usage instructions, etc.

TLC551, TLC551Y LinCMOS TIMERS is a monolithic timing circuit fabricated using the TI LinCMOS process. The timer is fully compatible with CMOS, TTL, and MOS logic and operates at frequencies up to 2 MHz. Compared to the NE555 timer, this device uses smaller timing capacitors because of its high input impedance. As a result, more accurate time delays and oscillations are possible.

TI TFP410 is a Texas Instruments PanelBus flat panel display product, part of a comprehensive family of end-to-end DVI 1.0-compliant solutions, targeted at the PC and consumer electronics industry.

This document describes the features and characteristics of a product, including support for IEEE P1394b Revision 1.33+, interoperability with Firewire, i.LINK, and SB1394, support for multiple transfer rates, and energy-saving features.

This document introduces TI's FireWire® devices, which are compliant with the 1394b standard and advance home networking and high-speed data transfer. The 1394 (FireWire®) connectivity technology enables simple, low-cost, high-bandwidth real-time data connectivity between computers, peripherals, and consumer electronics. These devices are suitable for consumer electronics such as camcorders, A/V receivers, SACD and DVD-audio players, DVCRs, digital TVs, computers, and peripherals. 1394-compliant products offer consumers a quick way to transfer large amounts of data between components and create robust, high-speed connections between devices throughout the home or office. The original specification, 1394a, called for data transfer rates of 100, 200, and 400 Mbps over a distance of up to 4.5 meters.

The TSB82AA2 OHCI-Lynx is a discrete 1394b link-layer device from TI, which supports PCI burst transfers and deep FIFOs.

This document describes a slight potential for PHY lock-up in a receiving node (including a repeating node) when a peer node is powered off or unplugged while transmitting data to the receiving node. If node B is unplugged or powered down while transmitting, its peer node A could see corrupted data on its port's twisted pair lines during the unplug or powerdown sequence. A rare condition has been discovered in which the node A PHY has the potential to enter a lock-up state after receiving a particular sequence of corrupted signals on the twisted pairs during unplug or powerdown of node B as node B is transmitting. Node A does see the bus reset event caused by the unplug or powerdown of node B but does not complete the collection of valid SelfID's. When in this state, the node A PHY is unaware of and does not respond to the bus reset caused by the plug-in of a new node C (or to the power-up of node B), this causes the just-connected node B or C to continuously issue bus resets. This causes the entire network to cease to function until the node A PHY is hard reset or disconnected from the network. This condition has never been reported in normal use; rather, it was observed in rigorous lab testing. All future releases of these devices shall have this issue fixed.

TSB15LV01 is a video signal processor integrated with a 1394 link layer controller from TI. It supports multiple CCD sensors and can be used in PC video camera, video conferencing, video capture, still picture capture, set-top boxes, video phone, gaming, webcam, robot, security and other fields.

This document describes the issue of disappearing IDLE in Beta systems and provides a workaround

SLLS418I is a 1394 interface chip produced by TI, supports 1394a-2000 standard, supports connecting multiple devices, and has automatic power-off and low power consumption.

This file introduces the features and characteristics of the TSB12LV32 TSB12LV32I product, which is a general-purpose link-layer controller that is compliant with IEEE 1394-1995 and P1394a and can be used for computer peripherals and consumer audio/video electronics.

This product is a IEEE 1394a-2000 fully compliant controller that supports 100/200/400 megabits per second of transmission speed.