ANALOG Manuals

ADXL320 is a low-cost, low-power, complete dual-axis accelerometer with signal conditioned voltage outputs, all on a single monolithic IC. The product measures acceleration with a full-scale ±5g, 60 Hz frequency. The ADXL320 features a small 4 mm × 4 mm × 1.45 mm LFCSP package, 2 mg resolution, wide supply voltage range of 2.4 V to 5.25 V, low power of 350 µA at VS = 2.4 V (typ), good zero g bias stability, good sensitivity accuracy, X-axis and Y-axis aligned to within 0.1° (typ), BW adjustment with a single capacitor, single-supply operation, and 10,000 g shock survival.

The SW06 is a four channel single-pole, single-throw analog switch with two normally open and two normally closed SPST switches with disable switches. It can be easily configured as a dual SPDT or a DPDT switch. The switch has a high static discharge destruction resistance and higher radiation resistance than analog switches designed with MOS devices.

This document provides technical information to properly design a JTAG emulator interface for Analog Devices, Inc. (ADI) processor targets

The AD9058 is a dual-channel 8-bit 50 MSPS analog-to-digital converter (ADC) with an integrated quadrature receiver. It features low input capacitance, high performance, and low power consumption.

The MAT03 is a low noise, matched dual PNP transistor with features such as low offset voltage, low noise, high gain, and high gain bandwidth. It is suitable for demanding preamplifier applications.

The AD775 is a CMOS, low power, 8-bit, 20 MSPS sampling analog-to-digital converter (ADC). The AD775 features a built-in sampling function and on-chip reference bias resistors to provide a complete 8-bit ADC solution. The AD775 utilizes a pipelined/ping pong two-step flash architecture to provide high sampling rates (up to 35 MHz) while maintaining very low power consumption (60 mW). Its combination of excellent DNL, fast sampling rate, low differential gain and phase errors, extremely low power dissipation, and single +5 V supply operation make it an ideal choice for various applications.

AD1849K is a serial-port 16-bit SoundPort® stereo codec with features including multiple channels of stereo input and output, digital signal mixing, on-chip speaker and headphone drive capability, programmable gain and attenuation, etc.

The ADXL204 is a high precision, single-/dual-axis MEMS® accelerometer with ±1.7 g resolution, low power consumption, and is suitable for applications such as vehicle dynamic control (VDC)/electronic stability program (ESP) systems, electronic chassis controls, electronic braking, platform stabilization/leveling, navigation, alarms and motion detectors.

AD524 is a precision monolithic instrumentation amplifier designed by Analog Devices for data acquisition applications requiring high accuracy under worst-case operating conditions. It features outstanding combination of high linearity, high common mode rejection, low offset voltage drift, and low noise.

The AD976/AD976A is a high-speed, low-power 16-bit A/D converter that operates from a single 5V supply. The part contains a successive approximation, switched capacitor ADC, an internal 2.5V reference, and a high-speed parallel interface. The ADC is factory calibrated to minimize all linearity errors. The analog full-scale input is ±10V.

ADuC702x series is a precision analog microcontroller with 12-bit analog I/O and ARM7TDMI® MCU.