Key facts
- Brand
- Elatec
- Model
- TWN4 MultiTech 2 M
- Documents
- 8
- Languages
- EN
- Last added
- 2023-10-19
Start here
Elatec TWN4 MultiTech 2 M HF Transponder Reader Quick Start Guide
The Elatec TWN4 MultiTech 2 M HF is a device designed for reading and writing RFID transponders operating at a frequency of 13.56 MHz. It is available in different versions to cover a wide range of transponder types. The device connects to a host system via either USB or RS232 cables.
Read onlineELATEC TWN4 MultiTech 2 M specifications
| HF Antenna | 13.56 MHz, 42 x 44 mm / 1.65 x 1.73 inch, 3 turns |
|---|---|
| LF Antenna | 125 kHz, 28 x 28 mm / 1.10 x 1.10 inch, 151 turns |
| BLE Support | 2.4 GHz, integrated in 1st gen; BLE SAM card in 2nd gen |
| Mounting Screws | M2.5 |
All ELATEC TWN4 MultiTech 2 M documents by type
Mounting, wiring and first power-up. Read it before the hardware goes in.
The shortest path to a working setup, usually only a few pages.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What is the TWN4 MultiTech 2 M?
It is an RFID reader/writer module that supports LF and HF tags, NFC, and optional BLE. It is designed for integration into host devices.
What are the compliance requirements for the TWN4 MultiTech 2 M?
It complies with FCC, EU, ISED Canada, Taiwan, and UK regulations. RF exposure compliance must be stated in the end-product manual.
What frequency does the TWN4 MultiTech 2 M HF transponder reader operate at?
The device is designed for reading and writing RFID transponders with a frequency of 13.56 MHz.
From: Elatec TWN4 MultiTech 2 M HF Transponder Reader Quick Start Guide
What happens to the device's LEDs when it enters the minimum power consumption mode?
When the device is not enumerated, both LEDs are turned off.
From: Elatec TWN4 MultiTech 2 M HF Transponder Reader Quick Start Guide
What is the USB suspend mode?
When the USB host signals suspend, the reader module turns off most power-consuming peripherals and stops detecting transponders; it resumes normal operation when the host resumes.
What is the TWN4 MultiTech 2 M LF HF designed to do?
It is intended to be integrated into a host device.