Installation guide for Whirlpool gas dryers MGDZ600T and MGDZ600W, covering venting, gas supply, electrical requirements, and closet/recessed installation…
This document provides installation instructions for Whirlpool gas dryers MGDZ600T and MGDZ600W. It details required ventilation, gas line specifications, electrical supply, and installation dimensions for closet or recessed setups. Venting must be to the outside using rigid or flexible metal venting, and gas supply must meet CSA certification standards for natural or LP gas. Electrical requirements are 120V, 60Hz, 15-20A fused AC only.
The guide includes spacing requirements for cabinets, recessed areas, and stacked washer/dryer installations. It also specifies hood styles (box or louvered) and exhaust vent dimensions (minimum 4" diameter). Installation must comply with local codes and include a manual shutoff valve within 6 feet of the dryer. This manual is written in Chinese.
| Gas Type | Natural gas or LP (propane/butane) |
|---|---|
| Gas Line Size | 1/8" NPT minimum plugged tapping |
| Electrical Supply | 120-volt, 60-Hz, AC-only, 15- or 20-amp fused |
| Exhaust Vent Diameter | 4" (102mm) minimum |
| Minimum Hood Height | 12" (305mm) from ground |
The dryer is designed for natural gas and is certified for LP (propane or butane) with appropriate conversion.
The gas line must include a 1/8" NPT minimum plugged tapping accessible for test gauge connection.
120-volt, 60-Hz, AC-only, 15- or 20-amp fused supply is required. A time-delay fuse or circuit breaker is recommended.
A 4" (102mm) diameter vent is required.