Teledyne LeCroy WaveRunner 6Zi/HRO Oscilloscopes Operator's Manual

Operator's manual for Teledyne LeCroy WaveRunner 6Zi/HRO oscilloscopes covering safety, setup, acquisition, triggers, measurements, analysis, and maintenance.


Teledyne LeCroy WaveRunner 6Zi/HRO Oscilloscopes Operator's Manual - cover page
Brand
Teledyne Lecroy
Category
Other Electronics
Document type
User Manual
Language
English
Pages
184
File format
PDF
File size
5.7 MB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
9384DF401317B6E14328A26E8A1A818F

About this manual

This operator's manual covers the Teledyne LeCroy WaveRunner 6Zi/HRO oscilloscopes. It begins with safety symbols, precautions, operating environment, cooling, calibration, cleaning, and power requirements, then describes the front panel, signal interfaces, setup, powering on/off, software activation, and language selection.

The manual explains MAUI touch-screen use, working with traces and zoom, acquisition controls, vertical and digital settings, timebase and trigger setup, display and persistence, cursors, measurements, math, memory, and analysis tools such as WaveScan and Pass/Fail testing. It also covers saving and recalling data, LabNotebook, reports, printing, file browser, utilities, preferences, maintenance, technical support, certifications, and warranty.

What's inside

  • Safety
  • Oscilloscope Overview
  • Signal Interfaces
  • Oscilloscope SetUp
  • Using MAUI
  • Acquisition
  • Trigger
  • Math and Measure
  • Analysis Tools
  • Saving Data (File Functions)

Specifications

AC Power100–240 VAC ±10% at 45–66 Hz; 100–120 VAC ±10% at 380–420 Hz; automatic AC voltage selection
Maximum Power Consumption500 W (500 VA) for WaveRunner models; 425 W (425 VA) for HRO models
Standby Power Consumption15 W
Operating Temperature5 to 40° C
Relative HumidityMaximum 80% for temperatures up to 31° C, decreasing linearly to 50% at 40° C
AltitudeUp to 3,048 m at or below 25° C
Warm-up TimeAt least 20 minutes prior to use
Cooling ClearanceMinimum 15 cm (6 inches) around the sides in benchtop configuration

Frequently asked questions

What is the operating temperature range?

The manual states an operating temperature of 5 to 40° C.

How long should I warm up the oscilloscope before use?

Warm it up for at least 20 minutes prior to use.

How should I clean the exterior of the oscilloscope?

Use a soft cloth moistened with water or an isopropyl alcohol solution.

How much clearance is needed around the instrument on a benchtop?

Leave a minimum of 15 cm (6 inches) around the sides.

Download PDF (5.7 MB)

More Teledyne Lecroy Manuals


View all Teledyne Lecroy manuals →