Teledyne LeCroy T3DSO2000A Series Digital Oscilloscope User Manual

User manual for the Teledyne LeCroy T3DSO2000A Series digital oscilloscope, covering safety, setup, triggers, serial decode, and measurements.


Teledyne LeCroy T3DSO2000A Series Digital Oscilloscope User Manual - cover page
Brand
Teledyne Lecroy
Category
Other Electronics
Document type
User Manual
Language
English
Pages
204
File format
PDF
File size
16.7 MB
Published
06 November, 2026
Updated
06 November, 2026
MD5 checksum
1575C512D3E9A9F673CE02BC7BC62F5E

About this manual

This user manual covers the Teledyne LeCroy T3DSO2000A Series digital oscilloscope. It begins with general inspection, safety information, care, cleaning, and end-of-life handling, followed by contents, introduction, first steps, document conventions, getting started, shutdown, and probe information.

Later sections cover front and rear panel overviews, connecting external devices, the touchscreen display, vertical and horizontal acquisition setup, trigger types, serial trigger and decode, cursors, measurement, math, and troubleshooting.

What's inside

  • General Inspection
  • Safety Information
  • Getting Started
  • Touchscreen Display
  • Front Panel
  • Horizontal and Acquisition Setup
  • Trigger
  • Serial Trigger and Decode
  • Measurement
  • Troubleshooting

Specifications

Ch1–Ch4 50 Ω input ratingMax <5 Vrms, +10 Vpk
Ch1–Ch4 1 MΩ input ratingMax <400 Vpk (DC+peak AC), DC-10 kHz
Operating temperature10°C to 40°C
Relative humidity85% RH up to 40°C
Altitude≤3000 m
AC input voltage and frequency100–240 V at 50/60 Hz; 100–120 V at 400 Hz
Power consumption80 W maximum, 50 W typical, 4 W standby
Fuse type2A/250V ('T' rated), 5 mm x 20 mm

Frequently asked questions

What accessories should come with the instrument?

The accessories listed are Calibration Kit, Utility Kit, Power Cord, and USB cable.

What is the specified operating temperature range?

The operating environment temperature range is 10°C to 40°C.

What fuse type is specified for the instrument?

The manual specifies a 2A/250V ('T' rated) fuse, 5 mm x 20 mm.

What should I check if the screen has no display after power on?

Check the power connection, the power switch, and whether the fuse has blown, then restart the instrument.

Download PDF (16.7 MB)

More Teledyne Lecroy Manuals


View all Teledyne Lecroy manuals →