Siemens QVE1901 flow switch for liquids in piping DN 20 to 200: switching values, installation, electrical connection, adjustment and technical data.
This document describes the Siemens QVE1901 flow switch for liquids in piping DN 20…200. It covers the mode of operation, the mechanical design with a paddle system, permanent magnet and reed contact, the ordering information (Flow switch QVE1901, 1592P01), engineering notes and the switching value table for water at 20 °C.
Installation and electrical connection are explained step by step, including the required smoothing sections, the upright installation position, the G¾ brass connecting nut tightening torque, and wiring through the EN 175301-803-A junction box. A section on adjusting the switching unit describes how the make (NO) and break (NC) contact types are set, followed by technical data, dimensions and notes on maintenance, decommissioning and disposal.
| Field of use | Water and antifreeze solutions (not suitable for ammonia) |
|---|---|
| Piping diameter | DN 20…200 |
| Type of switch | Reed contact |
| Contact rating | AC 230 V, 1 A / DC 48 V, 1 A |
| Max. switching capacity | AC 26 VA / DC 20 W |
| Medium temperature | -20…110 °C |
| Nominal pressure | PN 25 |
| Housing protection | IP 65 per EN 60 529 |
| Operation and storage temperature | -20…80 °C |
| Weight | 0.31 kg excluding packaging |
| Housing material | Polyamide, black |
It is suitable for water and antifreeze solutions, but not for ammonia. The medium must not freeze.
The maximum switching capacity is AC 26 VA or DC 20 W, with a contact rating of AC 230 V, 1 A or DC 48 V, 1 A.
The switching unit is set by hand: the make contact (normally open) is marked with a RED arrow and the break contact (normally closed) with a WHITE arrow.
No. The flow switch is maintenance-free and cannot be repaired by the user; a defective device must be returned to the manufacturer.