User manual for the Phocos CIS-N-MPPT 100/30 MPPT solar charge controller, covering installation, wiring, safety, LED status, night light, dimming, and…
Phocos CIS-N-MPPT 100/30 is an MPPT solar charge controller described in this multilingual user manual. It features automatic 12/24 V system voltage detection, negative grounding, IP68 enclosure protection, and charging profiles for flooded acid, sealed, and lithium (LiFePO4) batteries.
The manual covers general safety, maintenance and installation, connection and grounding, cable identification, display and warning functions, night light and dimming functions, test and safety functions, and low-voltage disconnect settings. This manual is written in German.
| Enclosure protection | IP68; protected in 1.5 m water depth for 72 hours |
|---|---|
| System voltage | 12/24 V with automatic detection |
| Grounding | Negative grounding |
| Charging profile (flooded acid batteries) | 4-stage: Main, Boost, Equalization, Float |
| Charging profile (sealed and lithium batteries) | 3-stage: Main, Boost, Float |
| Night light modes | 3: standard controller, dusk-to-dawn, evening/morning |
| Dimming output voltage | 0-10 V relative to battery negative; 1 V steps; 3% deviation |
| Dimming output impedance | 1000 ohm |
| Recommended minimum cable cross-section | 10 mm² |
| Maximum PV voltage | 100 V |
| MPPT charging stop voltage | Above 95 V |
| Low-voltage disconnect (voltage-controlled) | 11.0/22.0 V to 11.9/23.8 V in 0.1/0.2 V steps |
Four stages: Main, Boost, Equalization, and Float.
Three stages: Main, Boost, and Float.
Yes, it automatically detects 12 V or 24 V system voltage.
IP68, protected in 1.5 m water depth for 72 hours.