The Nokeval 6841 is a DIN rail mounted strain gauge and weighing transmitter with display, alarm relays, analog output, and RS-485 serial output.
The Nokeval 6841 is a DIN rail mounted strain gauge / weighing transmitter. It has a small display and push buttons for configuration without a separate programming device, plus two alarm relays, analog output, and RS-485 serial output with Nokeval SCL and Modbus protocols. The sensor can be connected using 6-wire measurement, and sensor excitation is about 10 V DC.
The manual covers the transmitter's introduction and specifications, installation, operation, front-panel user interface, configuration state, editing, monitoring, settings, and sensor setup. It also describes menu structure and configuration options for adapting the device to strain gauge or weighing applications.
| Input excitation | From transmitter 10 V ±10% 150 mA; externally 2.5…11 VDC |
|---|---|
| Measurement ranges | -40…+40 mV and -40…+100 mV |
| Analog current output | 0-20 mA or less (e.g. 4-20 mA) |
| Analog voltage output | 0-10 V or less |
| Serial protocols | Nokeval SCL or Modbus RTU or ASCII-CRLF |
| Baud rates | 1200…57600 bit/s |
| Alarm relay maximum load | 2 A / 250 VAC resistive |
| Supply voltage | 85-260 VAC or 24 VDC |
| Operating temperature | 0..60 °C |
| Weight | 250 g |
It is a DIN rail mounted strain gauge / weighing transmitter.
The device can be calibrated or taught in up to six points.
It supports Nokeval SCL, Modbus RTU, or ASCII-CRLF.
It accepts 85-260 VAC or 24 VDC.