Keystone Prima Densah Bur VT5/VT8/VS8 Sets Usage Guide

Usage guide for Keystone Prima Densah Bur VT5, VT8 and VS8 sets, covering drilling sequences for soft and hard bone in densifying and cutting modes.


Keystone Prima Densah Bur VT5/VT8/VS8 Sets Usage Guide - cover page
Brand
KeyStone
Category
Professional medical equipment
Document type
User Manual
Language
English
Pages
4
File format
PDF
File size
547 KB
Published
08 November, 2026
Updated
08 November, 2026
MD5 checksum
1E93CBB29334334E9858C69CD72A1BEF

About this manual

The guide compares the bur identification system for the VT5, VT8 and VS8 sets and lists pilot and subsequent Densah burs by geometry, major diameter and minor diameter. It describes densifying mode at CCW 800–1500 RPMs and cutting mode at CW 800–1500 RPMs.

It gives suggested drilling sequences for soft bone and hard bone (mandible) in charts for PrimaConnex, PrimaSolo, Keystone Genesis and Prima Plus. Notes cover osteotomy depth in densifying mode, the DAC protocol for extreme hard bone, ridge expansion, short implants, hard-bone finishing and sinus lift.

What's inside

  • Densifying Mode
  • Cutting Mode
  • Soft Bone
  • Hard Bone (Mandible)
  • Geometry
  • Densah® Bur Block Display
  • Pilot Bur
  • Taper
  • Straight

Specifications

Bur sets coveredVT5 Set, VT8 Set, VS8 Set
Densifying mode speedCCW, 800–1500 RPMs
Cutting mode speedCW, 800–1500 RPMs
Densifying osteotomy depth1.0 mm deeper than the actual implant final length

Frequently asked questions

What speeds are used in densifying and cutting modes?

Densifying mode uses CCW 800–1500 RPMs and cutting mode uses CW 800–1500 RPMs.

How deep should the osteotomy be in densifying mode?

It should be 1.0 mm deeper than the actual implant final length.

What should be done in hard bone (mandible) after full osteotomy preparation?

Use the next larger size Densah Bur to the 3 mm laser-mark depth so the crestal diameter is equal to or larger than the implant major diameter.

How are Densah Burs used for sinus lift cases?

Use them in full-step increments, such as 2.0 mm, 3.0 mm, 4.0 mm and 5.0 mm.

Download PDF (547 KB)

More KeyStone Manuals


View all KeyStone manuals →