InterApp IA Motion Actuator Installation and Maintenance Manual

This manual provides installation and maintenance instructions for InterApp IA Motion pneumatic actuators, covering safety, working conditions, and mounting…


InterApp IA Motion Actuator Installation and Maintenance Manual - cover page
Brand
InterApp
Category
Industrial Robot
Document type
User Manual
Language
English
Pages
4
File format
PDF
File size
946 KB
Published
13 November, 2026
Updated
13 November, 2026
MD5 checksum
2372CC6A38E29E3FC6322D1219301D76

About this manual

This document serves as an installation and maintenance guide for InterApp IA Motion pneumatic actuators, specifically models IA050 through IA1000. It outlines essential safety procedures, required working conditions, and technical data necessary for proper operation. The manual emphasizes that installation must be performed by qualified personnel and strictly adheres to state-of-the-art procedures to prevent damage or premature failure.

The guide details the mounting process for both single-acting and double-acting actuators, including specific steps for normal open and normal closed valve configurations. It also covers operational functions, rotation directions, storage requirements, and handling precautions to ensure the longevity and safety of the equipment.

What's inside

  • Introduction
  • Check before mounting
  • Working conditions and technical data
  • Installation
  • Mounting of single acting actuator
  • Mounting of double acting actuator
  • Operating function and direction of rotation
  • Storage
  • Lifting and handling

Specifications

Supply pressure (max)8 bar (116 Psi)
Supply pressure (IA800 max)7 bar (101,5 Psi)
Working pressure range2.5 bar (36 Psi) to 8 bar (116 Psi)
Operating temperature (Standard)-40°C (-40°F) to +80°C (+176°F)
Maximum particle size30 μm
Dew point requirement-20°C (-4°F) or at least 10°C below ambient

Frequently asked questions

Who is authorized to install the actuator?

The installation has to be carried out according to the state of the art and only by qualified personnel.

What fluids should not be used with the actuator?

Do not operate the actuator using inflammable, oxidizing, corrosive, explosive or unstable gases or liquids.

Can the actuator be disassembled while pressurized?

No, do not disassemble the actuator or remove end caps while the actuator is pressurized.

What is the standard rotation direction when port 4 is pressurized?

The standard rotation is clockwise to close.

Download PDF (946 KB)

More InterApp Manuals


View all InterApp manuals →