Installation instruction for the Honeywell EM 340/341 room electronic module, a ZBUS room indicator lamp used with System 99plus nurse call systems.
This installation instruction covers the Honeywell room electronic module EM 340/341 (Part No. 72575N1/N2/P1/P2/Z1/Z2/Z3), published by Novar GmbH, a Honeywell Company, in German, English and French. The EM 34x is a room indicator lamp designed as a ZBUS component of System 99plus and is used as a controller for patient and functional rooms without a speech function. It provides connections for call and cancellation units including calling circuit monitoring, bus lines, room components and the power supply.
The document describes mounting of the connection board and the plug-on EM 34x module, installation of the optional relay module with buzzer for door opener and local alarm functions, connection to the System 99plus ZBUS, compatibility notes and connection cable requirements. It also lists the variants: modules with and without bed bus, the connection board, and the relay module with buzzer. This manual is written in German.
| Operating voltage | 24 V DC |
|---|---|
| Power consumption | 84 mA @ 24 V DC |
| Mounting height | 1.5 ... 2.2 m above the floor |
| Connection cable | Twisted pair, e.g. I-Y (St) Y, n x 2 x 0.8 mm, or system cable 89734AH/AJ |
The EM 34x is compatible with the Clino Phon99, Opt99 (with limited functions) and 99plus systems. Firmware from V5.0R is required for the 72660C central group.
The connection mount is fastened at a height of 1.5 to 2.2 m above the floor, according to DIN VDE 0834-1:2000.
Each bus requires one twisted pair of wires, e.g. telecommunications cable I-Y (St) Y, n x 2 x 0.8 mm; the power supply can be carried in the same cable. Alternatively, system cable Part No. 89734AH/AJ can be used.
Claims under warranty are invalidated if damage is caused by non-compliance with the instructions, and no liability is accepted for resulting consequential loss.