Installation guide for the Fishman Powerjack preamp, covering pickup wiring, endpin jack, battery bag, second source, and specifications.
The Fishman Powerjack Installation Guide describes installation of the Powerjack preamp. It covers widening the endpin hole, soldering pickup wires to the preamp circuit board, installing the endpin jack and battery bag, and adding an optional second pickup source.
Specifications include a 9V alkaline battery power supply, 2,000-hour battery life, 4V peak-to-peak maximum output voltage, 10MOhm input impedance, output impedance under 5kOhm, 3dB system gain, and 94dB signal-to-noise ratio.
| Power Supply | 9 Volt alkaline battery |
|---|---|
| Battery Life | 2,000 hours |
| Maximum Output Voltage | 4V peak to peak |
| Input Overload | -.7dBV |
| Input Impedance | 10MOhms |
| Output Impedance | Less than 5kOhm |
| System Gain | 3dB |
| Signal-to-Noise Ratio | 94dB |
| Discrete Component Design | FET low noise class A input stage, bipolar class AB output stage |
It uses a 9V alkaline or lithium battery.
Battery life is 2,000 hours.
Yes. A second source such as a microphone or magnetic soundhole pickup may be added, and its output appears on the ring connection when a tip-ring-sleeve 1/4-inch jack is inserted.
Fishman recommends the job only for an experienced repair technician.