Fishman Powerbridge installation guide covering bridge fit check, replacement steps, grounding, and wiring options including Powerchip, stereo jack, and…
This guide covers installation of the Fishman Powerbridge as a replacement bridge, including checking the original bridge against the provided drilling template and mounting the bridge to the instrument.
It also describes wiring options: Powerchip active onboard blending, direct wiring to a stereo jack, and a passive volume circuit with specified components, plus an optional 3-way selector switch.
| Mounting holes | 7/64 inch |
|---|---|
| Passive volume potentiometer | 250k audio taper |
| Passive volume resistor | 330k |
| Passive volume capacitor | 820 pF |
| Passive volume capacitor | 1500 pF |
| Passive volume output decrease | 14 dB nominal |
Yes. Install the bridge by your preferred method using the provided drilling and routing templates and hardware.
Yes. All Powerbridge products should be separately grounded in addition to the shield of the Powerbridge signal wire using a traditional string-ground.
A 250k audio taper pot, 330k resistor, 820pF capacitor, and 1500pF capacitor.
Yes. A single pole, double throw (SPDT) 3-way switch with an on-off-on orientation can be added for piezo/magnetic pickup selection.