Installation instructions for the DUX AdjustaPit Basic 250mm silt pit, covering height adjustment, pipe connection, base preparation and backfill.
The DUX AdjustaPit Basic 250mm is a silt pit with an adjustable riser that can be screwed up or down through 140 mm to match finished ground level. The document explains how to connect pipework to the outlet, add inlets or outlets, and install the pit on a support base.
Installation steps cover excavation, a 100 mm sand or aggregate base, filling the pit with water to prevent flotation, backfilling, height adjustment, locking the riser with a stainless steel screw, and supporting the pit with a concrete collar. A warning states that the grate must always be installed or the pit suitably covered.
| Height adjustment | 140 mm total |
|---|---|
| Recommended Dux Coupling torque | 5.6 Nm |
| Outlet connection | 100 mm Dux Coupling, product code D156-44 |
| Excavation depth | approximately 800 mm below finished ground level |
| Concrete collar | 100 mm thick x 150 mm wide |
The riser can be screwed up or down for a total adjustment of 140 mm.
The outlet is connected using a 100 mm Dux Coupling, product code D156-44.
A stainless steel screw may be placed into the side of the AdjustaPit to lock the riser into position.
The grate must always be installed, or the pit must be suitably covered.