Dux Centreflush2 Cistern (CFDFUWWH2) Installation Instructions

Installation, adjustment, service, troubleshooting and warranty information for the Dux Centreflush2 wall-mounted toilet cistern.


Dux Centreflush2 Cistern (CFDFUWWH2) Installation Instructions - cover page
Brand
Dux
Category
Other products
Document type
Installation Guide
Language
English
Pages
2
File format
PDF
File size
383 KB
Published
13 November, 2026
Updated
13 November, 2026
MD5 checksum
2ABE28D617E907F9B35E08BF4F6AED87

About this manual

This document provides installation instructions for the Dux Centreflush2 cistern, model CFDFUWWH2, including setting out, mounting, flushpipe fitting, inlet and outlet valve service, push-button adjustment and troubleshooting. It also lists spare parts, warranty conditions and limitations.

The cistern supports adjustable flushing volumes of 4.5/3, 6/3 or 9/4.5 litres and is factory set for a 6 litre full flush and 3 litre half flush with a 6-litre pan. It uses a 40 mm flushpipe, has an internal overflow and complies with NZBC durability requirements of 5 years.

What's inside

  • Typical Layout for Dux Centreflush2 Cistern
  • INSTALLING
  • Installation & Adjustment
  • Service & Cleaning
  • Half Flush Adjustment
  • Full Flush Adjustment
  • Outlet Valve Removal
  • Push Button Adjustment
  • Maintenance and Troubleshooting
  • Cistern Breakdown & Spare Parts

Specifications

Factory flush setting6 litre full flush and 3 litre half flush with a 6-litre pan
Flushpipe diameter40 mm
Minimum flushpipe vertical length300 mm
Water inlet position66 mm below the top edge and at least 350 mm from the centreline
Button rod gap after adjustment1-2 mm
Durability5 years under NZBC requirements
Warranty, outer case and lid5 years from date of purchase
Warranty, internal valving and plastic components1 year from date of purchase

Frequently asked questions

What is the factory flush setting?

It is factory set for a 6 litre full flush and 3 litre half flush when used with a 6-litre pan.

How much gap should remain after adjusting the button rods?

There should be a 1-2 mm gap between the button rod and valve.

What should be checked if water continuously flows out of the cistern?

Check the outlet valve sealing washer and clean or replace it if worn.

Download PDF (383 KB)

More Dux Manuals


View all Dux manuals →