Analog Devices ADuC702x Debug Manual

About this manual

This document serves as a user guide for debugging the ADuC702x series of microcontrollers. It specifically addresses issues related to using the RDI Driver DLL with Keil uVision3, providing steps to resolve compatibility problems between the mIDAS-Link tool and specific versions of the development environment.

The manual outlines a step-by-step procedure for setting up a debugging session. This includes installing necessary drivers (such as J-Link), configuring the project in Keil uVision3 V3.22, selecting the correct device options, and utilizing the JLINKRDI.dll file to establish a connection with hardware evaluation boards like the EVAL-ADuC7026.

What's inside

• Goal
• Instrument
• Step 1: Install ADuC702x and Keil uVision3
• Step 2: Install J-Link driver
• Step 3: Connect the JTAG interface
• Step 4: Set up the project
• Step 5: Configure Keil
• Start debug

Specifications

Frequently asked questions

Which Keil version is supported for ADuC702x debugging?

The document specifies the use of Keil uVision3 V3.22.

What hardware is required for this debugging setup?

You need an EVAL-ADuC7026 board and a mIDAS-Link JTAG interface.

Which microcontroller models does this manual cover?

It covers debugging for ADuC7019, 20, 21, 22, 24, 25, 26, 27, and 28.