Agilent firmware upgrade guide for E44xxB, E44x8C, E82x7C and E82x7D signal generators using PSG/ESG Upgrade Assistant 5.12.
This Agilent firmware upgrade guide covers firmware upgrades for ESG/PSG signal generators, including E44xxB, E44x8C, E82x7C and E82x7D models. It describes how to install PSG/ESG Upgrade Assistant 5.12 and upgrade firmware using RS-232, GPIB or LAN connections.
The guide also lists required computer equipment and operating systems, explains how to check signal generator functionality before and after the upgrade, and provides interface setup steps for each supported signal generator model.
| GPIB factory address | 19 |
|---|---|
| GPIB address range | 0 through 30 |
| Warm-up time | at least five minutes |
| RS-232 baud rate | 19200 |
RS-232 or GPIB can be used for firmware upgrades on these models.
It must warm up for at least five minutes, and all errors must be cleared from the error queue.
The GPIB address is set to 19 at the factory, with an acceptable range of 0 through 30.
Windows XP, 2000, or Windows NT 4.0 with Service Pack 5 or above.