The Dell PowerConnect W-6000M3 Controller Module is a hot-swappable Controller Module for use within the Dell W-6000 Controller chassis. The W-6000 controller chassis is capable of containing up to four W-6000M3 modules, each of which can be configured as a master or local controller. Each W-6000M3 Controller Module is capable of supporting up to 512 campus connected access points (APs). For compatibility and configuration options, refer to “Configuration Options” on page 6.
This document provides installation instructions for the Dell PowerConnect W-6000M3 Controller Module, a hot-swappable component for the Dell W-6000 Controller chassis. It details hardware features, including 1000Base-X and 10GBase-X ports, a Gigabit Ethernet management port, and a serial console port. The guide specifies that the module requires ArubaOS 5.0.3 or later and supports up to 512 campus connected access points.
| Maximum Access Points Supported | 512 |
|---|---|
| Minimum Software Requirement | ArubaOS 5.0.3 or later |
| Power Draw per Module | 130 W max |
| Chassis Power Supply Requirement | 400 W |
No, the first W-6000M3 Controller Module must be installed in either Slot 0 or Slot 1.
Yes, the module is hot-swappable, allowing installation or removal while the chassis power is ON or OFF.