Dell PowerEdge R420xr 901D Reinforcement Kit Installation Guide
This document is an installation guide for the Dell 901D reinforcement kit used on Dell PowerEdge R420xr systems. It describes the procedure for installing the kit components and identifies the components inside the system that will be reinforced.
The guide lists the contents of the 901D reinforcement kit, including the electrical insulator, screws, bracket assembly, plastic block, system board lock, PSU lock bracket, PCIe card support bracket, battery clip, and server tie wraps. It provides step-by-step instructions for installing the PERC battery clip, replacing the system board lock, securing PCIe cards on risers, and installing the PSU lock.
| Electrical insulator (DPN 0M4XF) | 1 |
|---|---|
| Screw (DPN 23FYT) | 6 |
| Screw (DPN VW2J4) | 1 |
| Screw (DPN JNG28) | 3 |
| Bracket assembly (DPN FYGC8) | 1 |
| Plastic block (DPN TGNK5) | 1 |
| System board lock (DPN V5PYK) | 1 |
| PSU lock bracket (DPN X23KY) | 1 |
| PCIe card support bracket (DPN T621V) | 1 |
| Battery clip (DPN 5C6HG) | 2 |
| Server tie wrap (DPN 6N5P9) | 6 |
| Instruction manual (DPN 8JK58) | 1 |
Dell PowerEdge R420xr systems.
The PSU, PERC card, PCIe card riser 2, system board lock, and PCIe card riser 1.
Six.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.