Dell 10Gb Ethernet Pass Through -k for M1000e Software User’s Manual Rev 1.00
This Dell manual, Rev 1.00 (document number 32572), describes the installation and basic use of the Dell 10Gb Ethernet Pass Through -k for M1000e, written for users and system administrators responsible for setting up the I/O module. It explains the embedded software management of the 10GbE PTM, how to connect to the module and to the CMC, and how to update module and device firmware and software.
The document opens with a high-level overview of the I/O module structure and capabilities, including port groups, port link state reflection, link protocol mismatch conditions and LED behavior, then covers connecting to the 10GbE PTM CLI, a full command line interface reference, the software update procedure, and troubleshooting topics such as power, link connectivity and CLI recovery.
| Front panel ports | 16 ports divided into Group A (ports 1-8) and Group B (ports 9-16) |
|---|---|
| Supported internal link protocol | 10GBase KR |
| Group A port assignment | Ports 1 through 8, serving blades 1 through 8 |
| Group B port assignment | Ports 9 through 16, serving blades 9 through 16 |
| Module hardware | Three PHY devices and a micro-controller (CPU) |
It has 16 front panel ports in two groups: Group A (ports 1 through 8, serving blades 1 through 8) and Group B (ports 9 through 16, serving blades 9 through 16).
The supported link protocol for all internal ports is 10GBase KR.
Connect to the 10GbE PTM with an SSH client, run copy image from-file, send the .pfw file, then exit and power cycle the module with the racadm chassisaction command.
Both the green LED and the amber LED are off when the link is down.