The Dell Precision Workstation T3600 Owner's Manual provides information on how to remove and install components.
This owner's manual is for the Dell Precision Workstation T3600. It provides safety guidelines and step-by-step procedures for working inside the computer, including removing and installing components such as the power supply unit, cover, optical drive, memory, processor, system board, and other parts.
It also covers system setup, BIOS and password options, diagnostics, troubleshooting, diagnostic LEDs and error messages, technical specifications, and contacting Dell. The technical specifications section also lists configurations for T5600 and T7600.
| Processor | 4, 6, and 8 core Intel Xeon Processor |
|---|---|
| Instruction cache | 32 KB |
| Data cache | 32 KB |
| Mid-level cache per core | 256 KB |
| Last-level cache | up to 20 MB |
| Chipset | Intel C600 chipset |
| BIOS chip (NVRAM) | 8 MB + 4 MB serial flash EEPROM |
| Memory module connectors (T3600) | 4 DIMM slots |
| Memory module connectors (T5600) | 8 DIMM slots |
| Memory module connectors (T7600) | 16 DIMM slots |
| Memory module capacity (T3600/T5600) | 1 GB, 2 GB, 4 GB, 8 GB, and 16 GB |
| Memory module capacity (T7600) | 1 GB, 2 GB, 4 GB, 8 GB, 16 GB, and 32 GB |
| Memory type (T3600) | 1333 and 1600 DDR3 RDIMM ECC/Non-ECC |
| Memory type (T5600) | 1333 and 1600 DDR3 RDIMM ECC |
| Memory type (T7600) | 1333 and 1600 DDR3 RDIMM and 32 GB LRDIMM ECC |
| Front panel audio | HDA header one 2x5 pin connector |
| HDD back panel (T3600) | four 7-pin SAS/SATA connectors |
| HDD back panel (T5600) | one 36-pin mini-SAS connector, four 7-pin SAS/SATA connectors |
| HDD back panel (T7600) | two 36-pin mini-SAS connectors |
| Power connectors (T3600) | one 24-pin and one 8-pin connector |
| Power connectors (T5600) | one 24-pin and two 8-pin connectors |
| Power connectors (T7600) | one 24-pin and one 20-pin connector |
| Coin-cell battery | 3 V CR2032 lithium coin cell |
| Voltage | 100 VAC to 240 VAC |
Read the safety information that shipped with the computer, ground yourself, turn off the computer, disconnect cables and devices, and remove the cover.
Shut down the operating system, ensure the computer and attached devices are off, and if they do not turn off automatically, press and hold the power button for about 6 seconds.
A small flat-blade screwdriver, a Phillips screwdriver, and a small plastic scribe.
It indicates a problem has occurred with the system board.