This manual describes the installation and use of the Danfoss Link™ RS Room Sensor.
The Danfoss Link RS Room Sensor has a built-in temperature sensor that measures the ambient temperature and allows control of heating based on the room temperature where it is installed. It is battery powered by 2 x AA batteries and includes an LED button for display light and network test, plus temperature up/down buttons and a backlit display.
The installation guide covers mounting the back panel, inserting batteries, adding the device to the Danfoss Link CC Central Controller, performing a network test, factory reset, troubleshooting, technical specifications, and disposal instructions.
| Battery | 2 x AA alkaline, 1.5 V |
|---|---|
| Battery life | Up to 4-5 years |
| Ambient temperature | 0 to +40 °C |
| Transmission frequency | 868.42 MHz |
| Range in normal buildings | Up to 30 m |
| Transmission power | Max. 1 mW |
| IP class | IP 21 |
| Dimensions | 81 mm x 66 mm x 21 mm |
It is battery powered by 2 x AA batteries.
Connection to a system is made from the Danfoss Link CC Central Controller, and then a network test should be performed.
Remove the front, remove one battery, then press and hold the button while reinserting the battery until the LED flashes red for about 5 seconds; replace the front afterward.